HP5x5 Data Sheet

5ch SEPARATELY CONTROLABLE
5kV OUTPUTS

REF/
HP5x01

HP5x5

applications

Beam Steering in electron guns
Mass spectrometers
Surface science instruments

The HP5x5 provides 5 separately controlled 0 to 5kV outputs, at up to 300µA. Each one can be configured by the factory as positive or negative ( combinations of polarity are possible, e.g. 3 positive and 2 negative ). Each channel is controlled by its own 0 to +10V control signal, and each has its own 0 to +10V monitor output. The module is powered from +24V.dc, and draws 2 amps fully loaded.

HP5x5 pin connection & safety instructions

Electrical Specification
Input voltages: +24 volt at 2 amp. Negative input terminal common to HV earth return

Output Voltage 1: 20V to 5kV at 300µA.

Output Voltage 2 to 5: As output 1. All outputs are individually controlled.

Polarity: Each channnel can be factory set either positive or negative (combinations such as 3 positive & 2 negative are possible).

Please note the following applies to each of the 5 outputs:

Controls ( 5 separate ): 0 to +10V gives 0 to 5kV.

Voltage monitors: 0 to +10V represents 0 to 5 kV (all 5 outputs). Source resistance 10 kohm.

Ripple: Less than 150mV peak to peak on each output.

Line regulation: Less than 50ppm for 1V change in input.

Load regulation: Less than 50ppm.

Output Tolerance: Better than 2% of control voltage.

Temperature coefficient: Better than 200ppm per °C.

Operating temperature: 0°C to +45°C.

**Electrical Specification**
Input voltages:	+24 volt at 2 amp. Negative input terminal common to HV earth return
Output Voltage 1:	20V to 5kV at 300µA.
Output Voltage 2 to 5:	As output 1. All outputs are individually controlled.
Polarity:	Each channnel can be factory set either positive or negative (combinations such as 3 positive & 2 negative are possible).
*Please note the following applies to each of the 5 outputs:*
Controls ( 5 separate ):	0 to +10V gives 0 to 5kV.
Voltage monitors:	0 to +10V represents 0 to 5 kV (all 5 outputs). Source resistance 10 kohm.
Ripple:	Less than 150mV peak to peak on each output.
Line regulation:	Less than 50ppm for 1V change in input.
Load regulation:	Less than 50ppm.
Output Tolerance:	Better than 2% of control voltage.
Temperature coefficient:	Better than 200ppm per °C.
Operating temperature:	0°C to +45°C.

Mechanical Specification
Size: 216 x 155 x 52mm

Output cables: By flying leads. Each cable 0.5 metre of URM43

Input connector: Molex 6 way &12 way connector.

Ordering Information: State unit type HP5x5 and polarity mixture
e.g. HP5x5-3PN2N (3 positive and 2 negative).

**Mechanical Specification**
Size:	216 x 155 x 52mm
Output cables:	By flying leads. Each cable 0.5 metre of URM43
Input connector:	Molex 6 way &12 way connector.
Ordering Information:	State unit type HP5x5 and polarity mixture e.g. HP5x5-3PN2N (3 positive and 2 negative).


		Applied Kilovolts Ltd. webSite: http://www.appliedkilovolts.com/
	38 - 40 Eastbrook Road, Portslade, Sussex, BN41 1PB, United Kingdom Phone: +44 (0) 1273 439 440 Fax: +44 (0) 1273 439 449

Local distributor in Japan

APACE Science

APACE Science, Inc. webSite: http://www.apace-science.com/
Mitomo-Bldg.#2 - 6F, Ebisu-nishi 2-Chome,
2 - 8, Shibuya-Ku, Tokyo 150-0021
Phone: +81 (0)3 - 3463 - 3204 Fax: +81 (0)3 - 3463 - 3205