7.5V at 5A
|
|
|
|
|
||
| K1/60 | |||
|
isolated Filament module
7.5V at 5A |
|||
|
| Electrical Specification | |
| Input voltage: | 24V d.c. +0.5V at 3A maximum. |
| Output current: | 0.8A to 5A at up to +7.5 volt d.c. Isolated to 5 kV. |
| Control: | 0 to +10V gives 0 to 5A. (Internal & external potentiometer control also fitted). |
| Ripple: | Less than 200 mV peak to peak, ripple frequency 50 kHz. |
| Load regulation: | Less than 1% for 10% change in filament resistance. The output impedance of the power supply is electronically controlled to maintain the filament temperature as the filament ages |
| Line regulation: | Less than 1% for 0.5V change in 24V. |
| Temperature co-efficient: | 0.1% per °C. |
| Current monitor (pin 3): | 0 to 10V represents 0 to 5A (accuracy +5 %, source resistance 10 k.ohm). |
| Inhibit (pin 8): | Low = on, high or O/C = off. |
| Operating temperature: | 0 C to +45 °C. |
|
Mechanical Specification |
|
| Size: | 230 x 135 x 60 mm (HW series case). |
| Output cables: | Length 1 meter approx. |
| Pin connections: | As standard HP series with current monitor on pin 3 and on/off on pin 8. |
|
|
Applied Kilovolts Ltd.
webSite: http://www.appliedkilovolts.com/ |
|
|
38 - 40 Eastbrook Road, Portslade, Sussex, BN41 1PB, United Kingdom Phone: +44 (0) 1273 439 440 Fax: +44 (0) 1273 439 449 |
||
Local distributor in Japan
|
|
APACE Science, Inc.
webSite:
http://www.apace-science.com/ Mitomo-Bldg.#2 - 6F, Ebisu-nishi 2-Chome, 2 - 8, Shibuya-Ku, Tokyo 150-0021 Phone: +81 (0)3 - 3463 - 3204 Fax: +81 (0)3 - 3463 - 3205 |
| | Top of Page | specials | APACE Home | |
